SunStar SPS/A-3020 5030 SERIES - Page 53

53
(2) Correspondence of a chain No. to a pattern
D. Press ENTER key again.
C. Press ENTER key. Then the READY LED
comes to flicker. After reading a pattern, for
working the machine comes to be in sewing
available mode
B. Press NO key. When the cursor is located on
“NO:XXX”, input the pattern No. corresponds
to the chain No. “00”. For example, if you want
to work with No.“001”pattern, input [0][0][1].
A. Press No key. When the cursor is located on
“CHN_XX”, input [0][0]. At this time, must
input less number than the number of chain
sewing.
NO:001 CHN__00
XS:100%
YS:100% SP:2000
BC:000 PC:0000
NO:001 CHN__00
XS:100%
YS:100% SP:2000
BC:000 PC:0000
NO:001 CHN__00
XS:100%
YS:100% SP:2000
BC:000 PC:0000
E. Press NO key. If the cursor is located on
“CHN_XX”, input [0][1] for chain No. At this
time, input less number than the number of
practical chain sewing.
NO:001 CHN__01
XS:100%
YS:100% SP:2000
BC:000 PC:0000
G. Press ENTER key.
Then the READY LED comes to flicker. After
reading a pattern, for woring the machine comes
to be in sewing available mode.
※ If you want to back to the general sewing mode
from the chain sewing mode, set “054 Number
of Chain Sewing”should be set to “0”.
F. Press NO key. When the cursor is located on
“NO:XXX”, input the pattern No. that
corresponds to the chain No. “00”. For example,
if you want to work with No. “002”pattern,
input [0][0][2].
NO:002 CHN__01
XS:100%
YS:100% SP:2000
BC:000 PC:0000
NO:002 CHN__01
XS:100%
YS:100% SP:2000
BC:000 PC:0000