A.
Press MODE key.
B.
After moving to “4. Machine Test”by using direction
keys , press ENTER key.
C.
After moving to “6. Keyboard Test”by using
direction keys , press ENTER key.
D.
If you press a key, the relevant of the key
appears on the screen.
E.
If you want to finish keyboard test, press ESC key.
If you want to finish test menu, press ESC key.
F.
Back to the general sewing mode by pressing
ESC key.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
6.Keyboard Test
7.Input0 Test
8.Input1 Test
Key Code = 00
(7) Keyboard Test
It is to test if key is operated properly. If you press a key, value of the relevant value is shown on
key appears on the screen.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
<< Test Menu >>
7.Input0 Test
8.Input1 Test
9.Input2 Test
(8) Input 0 Test
It is to test if sensor input signal is operated properly. For testing, separate step motor output
connector from control box.
A.
Press MODE key.
B.
After moving to “4. Machine Test”by using
direction keys , press ENTER key.
C. After moving to “7. Input 0 Test”by using direction
keys , press ENTER key.
To Next Page
Loading...
