Suntex PC-3310 - Page 24

5.5.2 Calibration default value:
 ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ ġ
ġġġġġġġġġ
Calibration type: TECH-No Cal
Slope: -P9S+#Û&
Asy: 0 mV
Sensitivity: 100.0%
Determination:1.0000
Calibration value: None data
Auto back: Auto, 3 minutes
Code set-up: OFF
Note: The factory default of calibration presetting is “No Cal”, and the calibration value is “None”. It means
that the user has not calibrated the sensor with the transmitter yet. After finishing every calibration, the display
shows the calibration type and the calibration value. If the equipments have not been calibrated yet, the
measurement takes pre-set Asy and Slope into calculation. The factory default values are subject to change
without notice.
лй