58
TOOLS YOU CANNOT DO WITHOUT
• Allen wrenches 8, 6, 5, 4, 3, 2 • Side spanners 15, 10 (2), 9, 8
• Side open end spanners 17, 14, 13 • Spanners for quill assembly 40, 36, 34
(2 according to the required dimensions)
• Fine and larger Phillips screwdrivers • Tube repair kit
• Tyre levers • Inflation pump
Extra tools
• HG chain riveting device • Pullers or special cassette spanners
• Crank puller (with corresponding side spanner) • Ring nut spanner 14 (15) mm
• Fixture for cog loosening, 2 (lashes) • Centring fork
• Centring spanner • Gauges for chain and cog wear testing
Many service operations and repairs require professional knowledge and tools. Never start any modifications of your bike if you
are in any doubt about your ability to complete the repair. Insufficient service may endanger your life or health or cause damage
to your bike or harm to third parties.
BASIC INSTRUCTIONS
Front fork:
A bent or damaged fork should be replaced; never repair it.
Front wheel:
The wheel should be fitted in the front fork and tightened properly with locking nuts. The hub is sealed against the penetration
of moisture and dirt; however, it should be inspected regularly, in particular after riding over rough terrain (dusty or muddy ground
or ground containing potholes etc. is regarded as rough terrain throughout this Manual). The wheel should revolve freely when
turned by hand, with very low friction and backlash.
Riding with incorrectly adjusted quick-release mechanisms may result in the wheel shaking or loosening, which may result
in damage to the bike and serious injury or death; which may endanger your life or health or cause damage to your bike or to third
parties.
For this reason, it is necessary:
1) To ask your dealer to assist you in precise procedures for installing and removing the wheel safely.
2) To understand and apply the correct methods of wheel clamping with the quick-release mechanisms.
3) To check before each ride that the wheel is mounted safely. Removal or damage of the quick-release mechanism is very
dangerous and may result in cancellation of the guarantee and lead to serious injury or even death. Incorrect adjustment
of the quick-release mechanism may result in the wheel shaking or loosening, which may result in serious injury or death.
4) To check before each ride to ensure that the rims are not worn excessively; this may endanger your life or health or cause
damage to your bike or to third parties.
ENGLISH
To Next Page
Loading...