IntelliShot & FlexoShot: Operations Manual Page 5
SETTING UP THE DISPENSER
The dispenser must be placed on a horizontal surface. The surface must be strong enough to support
the dispenser and a full product load. The dispenser must be level for the refrigeration system to work
efficiently and for optimum dispense accuracy. Some models include adjustable legs to help level the
dispenser if necessary. Use a spirit level to verify the dispenser is level.
The dispenser should be placed at an appropriate serving and filling height so users can operate the
dispenser safely and without obstruction. It should be in a location where it can be overseen by trained
personnel.
Do not place the dispenser near a high heat source such as a fryer. It should be located 1 - 2-inches
(2.5 - 5 cm) away from a low heat source, such as a brewer.
Dispensers are not suitable for outdoor use.
The ambient (room) temperature range for efficient dispenser operation is 50°F - 122°F (10°C - 50°C).
Do not block the vents at the back or top of the dispenser. The vents must be unobstructed and clean
to prevent overheating and damaging the dispenser. Maintain 1-inch (2.5 cm) of air space on all sides
of the dispenser.
The dispenser legs must be securely attached for proper support. Do not remove the legs from the
dispenser or allow the dispenser to sit directly on the counter. Airflow and circulation under the
dispenser are essential for proper operation of the refrigeration system.
Operating the dispenser without the legs installed automatically voids the warranty.
SAFETY PRECAUTIONS
Failure to follow all safety precautions will void the warranty.
• Read all instructions in this manual and save it for future reference.
• Always plug the dispenser into an approved electrical outlet.
• Unplug the dispenser from its electrical outlet before servicing.
• Do not immerse the dispenser in water.
• Observe all safety precautions with this dispenser as with any electrical appliance.
• The dispenser must not be used in an area where a water jet could be used.
• This appliance is not intended for use by persons (including children) with a lack of experience and
knowledge or reduced physical, sensory, or mental capabilities unless they are supervised or given
instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised when in the vicinity of the equipment to ensure that they do not play
with it.
• This product has been designed and tested to operate in temperatures ranging from 50°F to 122°F
(10°C to 50°C).
To Next Page
Loading...
Need help?
General
