IntelliShot & FlexoShot: Operations Manual Page 8
OPERATING THE DISPENSER
PREPARING THE DISPENSER
Thoroughly clean the dispenser and components before use. The product compartment must reach
operating temperature before loading prechilled product.
1. Clean and dry the dispenser and all components.
2. Product should be prechilled to a temperature between 35°F to 40°F (1.7°C to 4.4°C) before
loading it into the product compartment.
3. Turn on the dispenser.
4. Allow the dispenser to run empty for at least one hour to reach operating temperature before
loading product. Refer to the side console display on the left side of the dispenser for the
current temperature of the product compartment.
5. Sanitize hands or wear clean gloves to load the product.
INSTALLING PRODUCT
SureShot dispensers are designed to accommodate three types of product packaging. Product may be
packaged in a single-use 5 L/1 G or 10 L/2.5 G prefilled bag (contained in a SureShot product case), a
bag-in-box (used with a SureShot ramp) or cartons (poured into a SureShot refillable tank). The model
of dispenser is typically chosen according to the product packaging.
If using a portion-control (IntelliShot) multi-product dispenser, product must be installed above the correct
valve according to the button panel (e.g., milk above the left valve and cream above the right valve).
Prefilled Dairy Bags (Product Case)
Product is supplied in sanitary, prefilled bags with attached tubes. The bag is placed in a product
case, which is then installed in the product compartment. If using a dairy bag that is less than 10
L/2.5 G (i.e., 5 L/1 G bag), a product case insert may be required to position a smaller bag to the
front of the product case. If unsure, please contact SureShot technical assistance for guidance.
Loading a Product Case
1. Insert a prefilled dairy bag into the product case with the bag fitment and dispense tube
aligned with the product case opening.
2. Adjust the bag to remove as many wrinkles as possible to improve product flow and
emptying.
Do not pull on the bag fitment or dispense tube as it may cause the bag to leak.
Product case
Product case
opening
To Next Page
Loading...
Need help?
General
