IntelliShot & FlexoShot: Operations Manual Page 10
Removing a Product Case and Empty Dairy Bag
1. Open the dispenser door.
2. Place a clean container under the tube to catch any residual product that may drain once
the valve door is open.
3. Open the valve door by turning the black thumbscrew counterclockwise.
4. Allow any residual product to drain. If desired, clamp the tube to reduce drips.
5. Remove the product case with the empty dairy bag from the dispenser.
6. Remove the empty dairy bag from the product case and discard.
Bag-in-Box
Product is supplied in a sanitary, prefilled bag with attached dispense tube, enclosed in a box. A
product ramp is used with a bag-in-box to slightly raise the back of the box for efficient product
evacuation.
Figure 13: Bag-in-box
Loading a Bag-in-Box
1. Open the dispenser door.
2. Place the product ramp in the product compartment with the ramp slanting down toward
the front of the dispenser.
3. Open the valve door by turning the thumbscrew counterclockwise.
Figure 14: Open valve door
4. Place a new bag-in-box in the product compartment above the correct valve with the tube
facing out.
5. Centre the tube in the valve opening. Remove and discard the plastic covering if present.
The tube should not be twisted, kinked, or pinched.
Figure 15: Correct tube placement
To Next Page
Loading...
Need help?
General
