Sutter Instrument MPC-200 - Page 14

12
MPC-385 SERIES OPERATION MANUAL – REV. 3.21K (20201120)
 Three MP-285/M manipulator mechanicals
 Three DB-25 cables (connect MP-285/M mechanicals to the controller).
 Three X285210 mounting adapter plates and hardware to attach mechanicals to their
mounting surfaces
 Three X285204 four-inch dovetail extensions for mounting headstages
4. MPC-385-4 (a four-manipulator system). Same as for the MPC-385-3, with the following
exceptions:
 Four MP-285/M manipulator mechanicals
 Four DB-25 cables (connect MP-285/M mechanicals to the controller).
 Four X285210 mounting adapter plates and hardware to attach mechanicals to their
mounting surfaces
 Four X285204 four-inch dovetail extensions for mounting headstages
 Four dovetail rod clamps
IMPORTANT
Once the MPC-385-series system has been unpacked, remove the two shipping screws,
indicated by the red warning tags, from each MP-285/M micromanipulator mechanical. These
screws must be removed before operating the manipulator. Save the screws, warning tags,
and hex wrench if future transport of the manipulator is needed. Once these screws have
been removed, handle the micromanipulator with care. The mechanism can be damaged if
the axes are moved with the screws in place.