Sutter Instrument MPC-200 - Figure 2-4. Configuration Switches on Rear of MPC-200 Controller Cabinet

MPC-385 SERIES OPERATION MANUAL – REV. 3.21K (20201120)
19
Figure 2-4. Configuration switches on rear of MPC-200 controller cabinet.
Switches 1, 2, 3 and 4 set the angle of the Diagonal mode movement.
The following table provides the angles that can be used and the DIP switch settings of
switches 1, 2, 3 and 4. As indicated in the inset to the left of the table, the angles fall into two
different quadrants according to whether the angles are more or less steep than 45 degrees.