ENGINE 3-19
• Remove the circlip and washer from the gearshift shaft.
( 09900-06107: Snap ring pliers
• Draw out the gearshift shaft 1, and then remove the gearshift
cam driven gear 2.
( 09900-09004: Impact driver set
NOTE:
When removing the gearshift cam driven gear, do not lose the
gearshifting pawl
3
, pin
4
and spring
5
.
• Remove the circlip 6.
( 09900-06107: Snap ring pliers
• Remove the washers 7, oil pump driven gear 8 and pin 9.
NOTE:
Do not lose the circlip, pin and the washers.
• Remove the starter idle gear 0 and its shaft A.
To Next Page
Loading...
