3-28 ENGINE
• Hold the gearshift forks 1 by hand when installing the gear-
shift fork shaft 2.
• Install the bearing pins 3 and C-rings 4 into the upper crank-
case.
• Install the countershaft assembly 5 and driveshaft assembly
6 into the upper crankcase.
NOTE:
* Be sure to install the bearing dowel pins
7
in their respective
positions.
* Install the countershaft end cap in the proper position
8
.
* Make sure that the countershaft assembly turns freely while
holding the driveshaft assembly. If it does not turn freely, turn
the gearshift cam to the neutral position.
• When installing the crankshaft journal bearings into the upper
and lower crankcases, be sure to install the tab 0 first, and
then press in the opposite side of the bearing. (!3-84)
$
Do not touch the bearing surfaces with your hands.
Grasp the bearings by their edges.
NOTE:
Before installing the crankshaft journal bearings, make sure that
the oil jets
9
in the upper crankcase are not clogged.
9 Oil jet (4 pcs) ................................... In the upper crankcase
To Next Page
Loading...
