ENGINE 3-29
• Install the cam chain tensioner guide 1 and the two dampers
2 properly.
NOTE:
Be sure to face the arrow mark on the damper towards the front
and rear, not towards the left and right.
• Install the O-rings (3 and 4).
$
Replace the O-rings with new ones to prevent oil leak-
age.
• Before installing the crankshaft assembly, apply molybdenum
oil solution to each crankshaft journal bearing.
) 99000-25140: SUZUKI MOLY PASTE
• Install the crankshaft assembly along with the cam chain into
the upper crankcase.
• Insert the right-and left-thrust bearings 5 with the oil grooves
facing towards the crankshaft web. (!3-85)
• Clean the mating surfaces of the crankcases.
• Install the dowel pins in the upper crankcase.
• Apply the recommended bond to the mating surface of the lower
crankcase as follows.
* 99000-31140: SUZUKI BOND “1207B”
NOTE:
* Make sure that the mating surfaces are free from moisture, oil,
dust and other foreign materials.
* Apply the bond thinly and evenly and assemble the crankcases
within a few minutes of application.
* Take extreme care not to apply any bond to the bearing sur-
faces.
To Next Page
Loading...
