Suzuki GSF650S - Page 253

6-16 ELECTRICAL SYSTEM
GENERATOR DRIVEN GEAR DAMPERS
Inspect the generator driven gear dampers for wear and dam-
age. If any defects are found, replace the generator driven gear
dampers as a set.
NOTE:
When installing the generator driven gear dampers, apply
SUZUKI MOLY PASTE to the damper surface.
) 99000-25140: SUZUKI MOLY PASTE
STATER COIL CONTINUITY CHECK
Measure the continuity between the lead wires of the stator coil
using a tester.
If there is no continuity, replace the stator.
Also, check that the stator is properly insulated.
" 09900-25008: Multi circuit tester set
* Tester knob indication: Continuity test (+)
ROTOR COIL CONTINUITY CHECK
Measure the continuity between the two slip rings

1 on the rotor
coil using a tester.
If there is no continuity, replace the rotor.
Also check that the rotor is properly insulated.
SLIP RINGS
If the slip rings are dirty, polish them with #400 sandpaper and
wipe them using a clean, dry cloth.
Then, measure the slip ring O.D. using vernier calipers. If it is
less than the service limit, replace the slip rings with new ones.
" 09900-20102: Vernier calipers (200 mm)
$ Slip ring O.D.
Service Limit: 14.0 mm
P1
P2
P3
P4
P1
P2
P3
P4
]
]
]