3-10 ENGINE
• Position the carburetor clamps as shown.
• After remounting the engine, route the wire harness, cables
and hoses properly. (!7-12 to -19)
• Install the gearshift lever to the gearshift shaft in the correct
position.
( Gearshift lever height
A
Standard: 55 mm
• Tighten the oil drain plug
1 to the specified torque.
# Oil drain plug: 23 N·m (2.3 kgf-m)
#2 #3 #4
LH RH
Carburetor clamp position (air cleaner side)
Carburetor clamp position (engine side)
#1
#2 #3 #4
#1
0 – 10˚
To Next Page
Loading...
