5B-8 Manual Transmission:
• With engaging each fork end to the cam groove, insert
the fork shaft (3).
• Apply thread lock to the screws and tighten them to
the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Bearing retainer screw (a): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
Countershaft
• Install the C-ring (1) and bearing pin (2) to the upper
crankcase.
• Install the countershaft assembly to the upper
crankcase.
NOTE
Align the C-ring with the groove of bearing
and the bearing pin with the indent on the
bearing.
• Turn the bearing to fit the bearing dowel pin in the
position “A”.
• Install the clutch push rod oil seal (3).
• Install the gearshift fork/gearshift shaft (4) and
gearshift shaft plug (5).
(a)
3
I837H1520026-02
1
2
I837H1520027-01
I837H1520028-01
“A”
I837H1520029-01
5
3
4
I837H1520030-01
To Next Page
Loading...
