Svantek SV 104IS User Manual

SV 104IS USER’S MANUAL______________________________________________________
17
3.3 The windshield
During use, it is strongly recommended that the SV 104IS is fitted with the supplied SA 122IS
antistatic windshield. To calibrate the dosimeter it is necessary to remove the windshield to gain access to
the microphone. It is not necessary to remove the windshield to record the voice note comments.
The SV 104IS uses windshield with reliable screwed technique to fit tightly onto the microphone
housing. To remove the windshield just unscrew it clockwise by holding the lower half of the foam and
windshield housing. See the markings engraved to unscrew. Once the SV 104IS has been calibrated, refit
the windshield by carefully screw it back counter-clockwise over the microphone again.
Figure 3-4 SA 122IS windshield
3.4 The mounting clips
Upon delivery, the SV 104IS will be fitted with the standard mounting clips made of natural leather.
Mounting clips can changed using a pliers.
Figure 3-5 SV 104IS standard mounting clips

Svantek SV 104IS Specifications

General

Brand	Svantek
Model	SV 104IS
Category	Measuring Instruments
Language	English