SV 104IS USER’S MANUAL______________________________________________________
41
5 SUPERVISOR BASIC OPERATIONS
This chapter explains data storage, the configuration setup of the dosimeter, and how to customize
the parameters via the Supervisor software.
With use of SA 104-5 docking station and SC 56 mini USB cable or SA 104-1 docking station and SC 156
micro USB, software and SV 104IS it is easy to:
set up required configuration parameters and upload these, so called SETUPS, straight
to the SV 104IS instrument
retrieve time history data to view and analyze your noise recorded charts, graphs,
with extended reporting functionality
5.1 Installing and connecting to PC
Insert the Supervisor software CD/DVD into your PC and run the installation program.
After installation you are ready to connect the SV 104IS dosimeter.
Plug the SC 56 mini USB cable into the SA 104-5 docking station powered with 12V power
supply, such as SA 33; note: SA 104-1 uses SC156 micro USB cable, SA 54 5V power supply
Plug the opposite side of the USB cable into the computer
Windows will install drivers for Svantek instruments if not previously installed
The SV 104IS is powered and charged directly through the docking station. Once enough
charged, the dosimeter screen will be switched on automatically with current charging
information only
Turn on the dosimeter (see chapter 4.3) - long press of the <ENTER> key
Once switched on, run the Supervisor software.
Figure 5-1 Supervisor splash screen
Notice: Supervisor software enables communication with multiple dosimeters. Therefore,
with the use of a docking station SA 104-5 or SA 104-1 it is pretty straightforward to connect all of them at
the same time. (see chapter 4.1 for details).
To Next Page
Loading...
Need help?
General
