[] FAQ
iiii:i_i,;_
ii..................................................
My remote control does not work.
What should I do?
• Check the antenna or cable connection to the main unit.
• Check the batteries of the remote control.
• Check if there is an obstacle between the infrared sensor window and the
remote control.
• Test the signal output. If OK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" on page 52.)
• Aim the remote control directly at the infrared sensor window on the
front of the unit.
• Reduce the distance to the unit.
• Re-insert the batteries with their polarities (+/- signs) as indicated.
• When there is an infrared-equipped device such as PC near this unit, it
may interrupt the remote control signal of this unit.
• Move the infrared-equipped device away from this unit, change the angle
of the infrared sensor or turn off the infrared communication function.
How come the Initial setup appears every : connect the RE Coaxial Cable tO the unit directly and run the initial setup,
time Iturn On this unit? • Make sure to complete the channel scan before turning offthe unit.
• Make sure autoscan has been completed.
(Refer to"Autoscan" on page 20.)
• Autoscan must be completed when you set up the unit for the first
time or move it to a location where previously unavailable channels are
broadcast.
• The selected channel may not be broadcasting.
Why Icannot watch some of TV programs? • When autoscan is interrupted and not completed,
some channels will not be received. Make sure to complete.
(Refer to"Autoscan" on page 20.)
• The selected channel cannot be viewed by the"Child Lock"setting.
(Refer to "Child Lock" on page 28.)
• The unit requires some kind of antenna input. An indoor antenna (rabbit
ears), an external antenna, or an RF coaxial cable from your wall or cable
receiver/satellite box needs to be plugged into the unit.
' Check if the right input mode iS selectee by pressing [INPUT SELECT] or
HOw €0me there is no image from the .... using [CH A/V]. (Refer to"Switching Each Input Mode' on Page 17.)
connected external devices? • Check the antenna or cable connection to the unit.
• Many digital channels have alternate channel numbers. The unit changes
Whenever I entered channel number, the numbers automatically to the ones signifying the broadcasting
it changes automatically, stations. These are the numbers used for analog broadcasts.
' clean the disc
, Ensure the d sc is correctly inse[ted.
"_ "scc n ot-e a ed- ck I °Check fthedsc sdefectvebytrynganotherdsc
!vly_ a n D p y Da .: _ ,Cance!theparent a ock or change the contro eve!
s mere any way can pay my a sc
, Insert a correct disc that plays back on this unit.
Handle a disc with special care so that it does not have fingerprints,
scratches or dusts on its surface.
• Captions that are delayed a few seconds behind the actual dialogue are
Why are captions not displayed entirely? common for live broadcasts. Most captioning production companies can
Or. captions are delayed behind the display a dialogue to maximum of 220 words per minute. Ira dialogue
dialogue, exceeds that rate. selective editing is used to insure that the captions
remain up-to date with the currentTV screen dialogue.
How Can I set the clock ? ' There is no clock function on this unit.
EN
To Next Page
Loading...
