13. BODY COVERS
13-11
Inner cover
Disassembly
Take off four screws from the speedometer cover
(Screw x 4).
Disconnect the cable and connector of the
speedometer.
Loosen two bolts from under speedometer
(Screw x 2).
Remove the speedometer and speedometer
cover.
Loosen one bolt that holds the inlet cap of
radiator (Bolt x 1).
Loosen two bolts that hold the fuel filler (Screw x
2).
Remove the fuel filler cap and bushing.
Disassemble the main switch cap.
Loosen one screw at the rear of the inner box
(Screw x 1).
Remove the inner box.
Assembly
In reverse order of the disassembly as described
above.
Caution
Screw x 4
Bolt x 2
Screw x 1
˙While taking off the fuel filler cap, do not let it
fall to the ground that may cause damage to
the cap or personal injury.
˙After the inner box is taken off, reinstall the
fuel filler cap to prevent any foreign material
from entering into the fuel tank.
Bolt
x 1
Bolt
x 2
To this chapter contents
To Next Page
Loading...
