EasyManuals Logo

Sym Joyride125 User Manual

Sym Joyride125
203 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
2. MAINTENANCE INFORMATION
2-9
AIR BLEED OPERATION
Connect a transparent hose to draining valve.
Hold the brake lever and open air bleeding valve.
Perform this operation alternative until there is
no air inside the brake system hoses.
Caution
Before closing the air bleed valve, do not
release the brake lever.
ADDED BRAKE FLUID
Add brake fluid to UPPER limit lever.
Recommended brake fluid: DOT3 or DOT4
WELL RUN brake fluid.
Caution
Never mix or use dirty brake fluid to prevent
from damage brake system or reducing
brake performance.
BRAKE LINING WEAR
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
It is not necessary to remove brake hose
when replacing the brake lining.
Remove the brake clipper bolt, and take out the
clipper.
Caution
Do not operate the brake lever after the
clipper removed to avoid clipping the brake
lining.
Pry out the brake lining with a flat driver if lining
is clipped.
Transparent hose
A
ir bubble
Drain valve
Master cylinder
cap
Plate
diaphragm
Diaphragm
LOWER
UPPER
Lining
Brake
caliper
Brake disk
Caliper
bolt
To this chapter contents

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sym Joyride125 and is the answer not in the manual?

Sym Joyride125 Specifications

General IconGeneral
BrandSym
ModelJoyride125
CategoryMotorcycle
LanguageEnglish

Related product manuals