Sym Joyride125 - Switch and Horn Service

17.ELECTRICAL SYSTEM
17-13
Replacing Bulb of Number Plate Lamp
Remove the rear cover (screw x 4).
Remove the lamp lens (screw x 2).
Replacing bulbs of Tail light, Brake light, and
Rear winker light
Remove the rear cover (screw x 4).
Remove the lamp lens for tail light and rear
winker light (screw x 4).
Switch/Horn
Main Switch
Inspection
Remove the front cover (bolt x 2, screw x 8).
Disconnect the main switch.
Check the continuity between two points as
indicted below:
BAT1 BAT2 IG E
LOCK
● ●
OFF
● ●
ON
● ●
Wire
Color
Red Black
Black/
White
Green
※This inspection table is also applicable to the
engine switch.
Winker light
screw
Screw
×
××
×
2
screw
×
××
×
2
main switch
Winker bulb
Tail / brake bulb
To this chapter contents