17.ELECTRICAL SYSTEM
17-7
Inspection on SCR
Remove the bumper by loosening four screws
(screw x 4).
Remove the right side cover by loosening three
screws (screw x 3).
Disconnect 3P and 4P connectors to remove the
SCR.
Item Check Points Standard Value
Main switch
connection
R – B Battery voltage
(ON)
Battery
connection
R – G Battery voltage
Charging coil Y – Y
0.4 – 0.8Ω
ΩΩ
Ω
If the readings measured are not normal, check
parts in the circuit.
If the parts are normal, then trouble is in the
wiring.
If there is nothing wrong with parts and wiring,
replace the SCR.
Inspection on the Charging Coil
Caution
Measure the resistance between each yellow
wire of the SCR.
Standard resistance: 0.4-0.8
Ω
ΩΩ
Ω
The test can be carried out without removing
the charging coil from the engine.
Regulator rectifier
To this chapter contents
To Next Page
Loading...
