To this chapter contents
1. General Information
y Do not let the wire harness been twisted when
installation.
1-8
y Wire harnesses routed along the handlebar
should not be pulled too tight or have excessive
slack, use rubber covering against adjacent or
surrounding parts in all steering perimeters.
y Before operating a test instrument, operator
should read the operation manual of the
instrument. And then, conduct test in
accordance with the instruction.
y Use sand paper to clean connector
pins/terminals if rust is found. And then
continue the connection operation.
Clean rust
Do you know how to set the
instrument to its
measurement position and
the insert locations of its
two probes?
To Next Page
Loading...
