Getting Started
2-5
2.5 Logging into the CB3000
There are two ways to log into the CB3000 console:
• Using the CB3000 Discovery Tool included on the CB3000 CD
• Using a Web browser such as Microsoft Internet Explorer 5.0 or later, or Netscape Navigator 6.0 or later
Typically, users locate the CB3000 using the Discovery Tool, then save the URL link as a browser “favorite” and
use the saved link later to access the console directly through a Web browser. See the following sections for
more details.
If using the Discover Tool to connect to a CB3000, the session is opened using https.
2.5.1 Discovery Tool Login
Included on the CB3000 Client Bridge CD is a utility called the Discovery Tool. When run, the Discovery Tool
scans the network for all running CB3000 units and “discovers” them. When a unit is discovered, it is listed
within the Discovery Tool interface. By selecting a discovered unit within the Discovery Tool, you can log into
its console.
Note If the subnet of the PC where the tool is run is different from the current ip-
address of the CB, a window pops up which gives the option to change the ip-address
of the Client Bridge. This is password protected (use admin/symbol).
To run the Discovery Tool:
1. Locate the Discovery Tool (discover.exe) on the CB3000 CD, and copy it to a desktop on the same network
as the CB3000 you wish to access.
2. Double-click on the discover.exe file to launch the utility, and run a network scan. The scan starts
immediately; when or if a CB3000 unit is discovered, a screen similar to Figure 2.3 is displays.
100 Mbps Orange Blinking 100 Mbps transmit/receive
10 Mbps Green ON 10 Mbps connection over LAN
10 Mbps Green Blinking 10 Mbps transmit/receive
Table 2.1 CB3000 LEDs (Continued)
LED Label Activity Description
To Next Page
Loading...
