Issue 3: Mar 96 TMSL 097-45018-02
Page 31
REMOVE T1
(RMV-T1)
MESSAGE CATEGORY: SURVEILLANCE
TYPE: INPUT/RESPONSE
This command removes an equipment unit or facility from service, and places it into a maintenance
state. When the equipment or facility is in a maintenance state, service-affecting diagnostic routines may
be performed or the unit may be replaced. No alarms are generated at the near end office as a result of
this command.
COMMAND
RMV-T1:[<tid>]:<aid>:<ctag>;
aid: MRC-1-x = Multi-Reference Controller A (x = span 1 to 4 or ALL)
MRC-2-x = Multi-Reference Controller B (x = span 1 to 4 or ALL)
PSM-x-y = Precision Sync Monitor card (x = 1 to 9, y = span 1 to 4
or ALL)
Example:
RMV-T1::PSM-1-3:133;
This example, tagged as command 133, removes PSM-1, span 3 from service.
COMPLETED RESPONSE
<sid> <date> <time>
M <ctag> COMPLD
;
Example:
TELECOMSOLUTIONS 95-01-11 15:48:14
M 133 COMPLD
;
ERROR RESPONSE
<sid> <date> <time>
M <ctag> DENY
<errcde>
;