Issue 3: Mar 96 TMSL 097-45018-02
Page 53
RETRIEVE ALARMS (Contd)
conddescr (Contd):
For GTI only:
FUSE OR POWER FAIL = DCD-LPR fuse has blown, or the office
battery has failed
GPS LOSS OF SIGNAL = GPS loss of signal
GPS INVALID = GPS timing is invalid
GTI OUT FAULT = primary rate output of the GTI has been
faulted by a short, improper termination,
or equipment failure
GTI-FAIL = hardware failure; for field service/engi-
neering use only
OSCA LOSS OF SIGNAL = no signal energy detected on OSC input
GTR POWER FAULT = power supply has been faulted by a short,
an open, or equipment failure
GTR COMM FAILURE = The GTI has timed out waiting for a sta-
tus message from the GTR
GTR FAIL = hardware failure; for field service/engi-
neering use only
<null> = no descriptive information exists
Example:
TELECOMSOLUTIONS 96-02-08 15:04:14
M 145 COMPLD
"MRC-1-4:MJ,LOS,NSA"
"MRC-1-4:MJ,MTIE1,NSA"
;
This example, in response to command 145, shows that MRC A, span 4, has two major alarms: loss
of signal, and MTIE 1-second alarms. This also shows that an E1 input is used; if an analog input
was used, the command would have been denied.
To Next Page
Loading...
Need help?
General
