SA160
AIRCRAFTA I R C R A F T
Symphony
AIRCRAFT
The following page contains easy steps for initial setup and operation of
yourchronometer.
You will want to set your chronometer's universal and locall time
functions.Thisiseasilydonebyperforming the following steps:
With power on, place the selector switch in the 'straight
up' position (between the 'RUN' and 'STOP' positions). The display
shouldgoblank.
Turn the power off for a few seconds, then back on. After a
short period of time, the display will alternate between 'UTC?' or
'LOC?'.
First, you should set UTC time. When the display shows
'UTC?', quickly move the selector switch to the 'HRS' position.
When the 'hours' value gets to the correct hour, move the switch to
the 'MIN' position. Set the 'minutes' value a few ahead of actual
time to allow you to set seconds. Move the selector to 'SEC' and set
it to your desired future time. Move the switch to the 'STOP'
position.
When the preset time equals the current time, move the
selector switch to the 'straight up' position as before. The display
will read 'UTCrdy'. Wait for this message to disappear, then move
the selector to any desired position. (You can now check 'UTC' for
4.16 INITIAL CHRONOMETER SET UP
SETTING UNIVERSAL TIME COORDINATED (UTC):
STEP 1 -
STEP 2 -
STEP 3 -
STEP 4 -
Feb 25, 2005
21 of 27
To Next Page
Loading...