AIRCRAFT
SA160
AIRCRAFTA I R C R A F T
Symphony
(hours) and allowing each to increment up to the desired value,
then quickly moving the selector to the next desired position.
When this is completed, move the selector to 'STOP' to hold the
current value. If you made a mistake, move to the 'RUN' position
forafewseconds,thensetagain.
When you are ready to begin timing, move the selector to
the 'RUN' position. The graph will fill to full scale and the timer will
begin counting down. The graph now represents the percentage
of 'pre-set' time remaining. This is very handy for an instrument
approach or for timing when to switch fuel tanks. It relieves you of
the chore of noting clock times and calculating minutes remaining,
etc.
When time expires,the entire display flashes alerting you
to this fact. Move the selector switch to the 'STOP' position to clear
the countdown timer mode. NOTE: You can dear the countdown
timer mode any time it is running by moving the switch to the
'stop'position.
The initial set-up of the EC-100 is performed at the aircraft factory. In the
event that a system re-initialisation would be required, refer to the VM-
1000 installation manual provided with your aircraft for the proper
procedures.
The EC100 system provides several categories of easily accessed
information. Select the desired category by pressing the W button to go
STEP 2 -
STEP 3 -
4.18 INITIAL EC100 SET UP
4.19 EC100 SYSTEM OPERATION
Feb 25, 2005
24 of 27
To Next Page
Loading...