Syntec 22/220 Series User Manual

机床产品/Machine Tool Products
              –
              22/220 Series Controller Application Manual
Software Installation、Data Backup/Restore–62
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
13.1 System Backup
Path
Eight Key: F10 Next →F4 System Admin.→ F2 Backup Sys.
Five Key:F10 Next → F4 System Admin.→ F2 Backup Sys.
Function
This button is used to backup system data of controller. There are two types of backup: Syntec
Backup (SB) and Maker Backup (MB).
SB will back up your entire system controller's folders into a backup file, even the software files. It
isthe most complete backup, but please note that this backup does not include the NC files, and
cannot backup selectively.
SB can further be saved to external device or internal storage to prepare for contingencies.
Internal SB is not mandatory, but there are TWO notices showing the internal backup has not bbaeen
done yet. 1: "About" function key is orange 2: In About screen, a red warning message "Can't Find SB
Restore Files" is in the bottom.
MB can only used to backup the common development files such as PLC, Macro, etc., but it'a able to
choose the data the user wish to back up, which provides a higher flexibility.
Syntec Back (SB) Files are:
DiskC
Shared folder
OpenCNCfolder
OCResfolder
StdMMIRes folder
PrdMMIResfolder
App folder (valid version: 10.118.40B, 10.118.41)
Fonts folder (valid version: 10.116.36R, 10.116.46, 10.117.46)
CEINIT.XML

Syntec 22/220 Series Specifications

General

Brand	Syntec
Model	22/220 Series
Category	Controller
Language	English