ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
- 18 -
User Setting Project
KT-LCD8S meter user setting project：
◇ General project setting
◇ P parameter setting
◇ C parameter setting
General Project Setting
○ Maximum Trip Speed
Under power off status, hold button long (SW), the meter is turned on. Within
5 seconds after boot-up, hold button (UP) and button (DOWN)
simultaneously for about 2 seconds, the first is to enter the maximum riding speed setting
interface, press button shortly (SW) ,then the speed display column flashes. Press
button shortly (UP) or button (DOWN) in order to set the maximum riding
speed value. The default maximum riding speed value was 25KM/H. When the speed of
the electric vehicle exceeds the set value, the motor will be stopped driving.
Under the setting maximum riding speed interface, if there’s no button operation
on the meter for more than 1 minute, and then the meter will automatically return to
display 1, and the original set values will be saved.
After finishing the maximum riding speed setting, press button shortly (SW) ,
To Next Page
Loading...