SZKTDZ KT-LCD8S - P4 Throttle Startup Setting

ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
- 23 -
Enter P3 parameter setting interface after P2 parameter setting is finished, press
button and P3 parameter column flashes.
P3 parameter setting interface
P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "imitation torque control" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "speed control" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press button (UP) or button (DOWN) for selection. P3 parameter setting
method is the same to that of P2.
After finishing P3 parameter setting, press button (SW) to save the current set
values, then press button (DOWN) to enter P4 parameter setting interface.
○ P4 Throttle Startup Setting
Enter P4 parameter setting interface after P3 parameter setting is finished, press
button, P4 parameter column flashes.