SZKTDZ KT-LCD8S - C14 Power-Assist Tuning Parameters Setting

ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
- 42 -
After finishing C13 parameter setting, press button (SW) to save the current
value and then press button (DOWN) to enter C14 parameter setting interface.
○ C14 Power-assist tuning parameters Setting
Enter C14 parameter setting interface, press button (SW), C14 parameter bar
flashes.
C14 parameter setting interface
C14 is the parameters of power-assist tuning setting, with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press (UP) button or (DOWN) button for short to make selection.
C14 parameter definition table:
C14 Value
Assist strength of intelligent pedal motor
1
Weak assist strength of motor
2
General assist strength of motor
3
Stronger assist strength of motor
After finishing C14 parameter setting, hold button (SW) long for about 2
seconds to exit C parameter setting environment and return to the display 1.