After finishing C1 parameter setting, press button (SW) to save the current
value and then press button (DOWN) to enter C2 parameter setting interface.
○ C2 Motor Phase Classification Coding Setting
Enter C2 parameter setting interface after C1 parameter setting is finished, press
button (SW),C2 parameter column flashes.
C2 parameter setting interface
C2 is motor phase classification coding setting, it is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used. C2 setting
range is 0-7, press button (UP) or button (DOWN) for selection.
After finishing C2 parameter setting, press button (SW) to save the current
To Next Page
Loading...
