ELECTRIC BICYCLE METER KT—LCD8S Product User Manual
- 26 -
original set parameters will be saved.
C Parameter Setting
After finishing P5 parameter setting, P5 parameter column stops flashing. Within 1
minute after stopping flashing, press button (DOWN) to enter C parameter setting
environment.
○ C1 Power-Assist Sensor and Parameter Select Setting
Set C1 parameter first after entering C parameter setting environment, press
button, C1 parameter column flashes.
C1 parameter setting interface
C1 is power-assist sensor and parameter select setting, its definition is shown in
following table. C1 setting ranges between 0-7, press button (UP) or button
(DOWN) for selection.
C1 parameter definition table：
To Next Page
Loading...