To Next Page

To Previous Page

TB8100 Service Manual Power Management Unit Disassembly and Reassembly 257

14.8 Refitting the Front and Rear Panels

Refer to Figure 14.1 on page 253.

1. Hold the two modules firmly together and fit the front panel over the

heatsinks. Ensure that the shield remains in place. You may find it

easier to fit the front panel while the PMU is lying on its side. This

way the shield is held in place between the heatsinks.

2. Refit and tighten the five M4 Torx screws to secure the front panel to

the heatsinks and shield.

Note Make sure that all connectors are correctly located in their respec-

tive holes in the panel before fully tightening the screws.

3. Refit and tighten the M4 Torx screw grounding the front panel to the

AC converter board.

4. Fit the rear panel over the heatsinks.

5. Slide the fibreglass DC input

insulator in behind the DC input

ter minals. Make sure it fits into the

slot in the board

b and is correctly

located on its mounting tabs in the

rear panel

6. Refit and tighten the five M4 Torx

screws to secure the rear panel to

the heatsinks and shield.

Note Before fully tightening the

screws, make sure that all con-

nectors, switches and the fibre-

glass insulator are correctly

located in their respective holes

in the panel.

7. Refit and tighten the M4 Torx screw grounding the rear panel to the

AC converter board.

Tait TB8100 Service Manual

Other manuals for Tait TB8100