TB8100 Service Manual Reciter Disassembly and Reassembly 99
© Tait Electronics Limited September 2006
4 Reciter Disassembly and Reassembly
Important This equipment contains devices which are susceptible to
damage from static charges. Refer to “ESD Precautions”
on page 17 for more information on antistatic procedures
when handling these devices.
This chapter provides information on how to remove and refit the covers
and front and rear panels.
Note Unless otherwise noted, for the sake of simplicity and clarity, the
instructions and illustrations in this chapter refer to a UHF
(H-band) reciter fitted with an isolated system interface board.
However, the same basic procedures and techniques apply to other
models of reciter and system interface board.
To Next Page
Loading...
