Tait TP9100 - Page 108

108 Disassembly and Reassembly TP9100 Service Manual
© Tait Electronics Limited May 2005
Removing the
LCD Assembly and
the Front-Panel
Loom
The circled numbers in this section refer to the items in Figure 5.6.
1. Release the lock of the LCD connector on the back of the main-
shield assembly
C and unplug the loom of the LCD assembly D.
2. Remove the LCD assembly
D.
3. Release the lock of the front-panel loom connector and disconnect
the front-panel loom
B.
Figure 5.6 Removing the LCD assembly and the front-panel loom
B
front-panel loom
C
main-shield assembly
D
LCD assembly
3654z_01
C
D
LCD connector
loom of LCD assembly
front-panel loom
connector
B