TP9100 Service Manual Disassembly and Reassembly 109
© Tait Electronics Limited May 2005
Removing the
Rear Panel and the
Flexible Accessory
Board
The circled numbers in this section refer to the items in Figure 5.7.
1. Turn the lock of the dummy cover
B clockwise by a quarter turn,
and remove the dummy cover.
2. With two thumbs, push the top of the rear panel
C off the chassis F,
and unclip the rear panel. If necessary, carefully insert a flat-bladed
screwdriver at the top between the rear panel and the chassis.
3. Remove the rear-panel seal
D. The rear-panel seal is self-adhesive and
must be replaced each time it is removed.
4. Remove the flexible accessory board
E.
Figure 5.7 Removing the rear panel and the flexible accessory board
B
dummy cover
C
rear panel
D
rear-panel seal
E
flexible accessory board
F
chassis
C
B
D
E
F
3657z_01
To Next Page
Loading...
