TP9100 Service Manual Disassembly and Reassembly 111
© Tait Electronics Limited May 2005
Removing the
Speaker
The circled numbers in this section refer to the items in Figure 5.9.
1. Use a Torx T6 screwdriver to unscrew the screw
B and remove the
speaker clamp
C.
2. Use a small flat-bladed screwdriver to remove the speaker
D.
The speaker adhesive ring
E must be replaced each time the speaker
is removed.
3. If necessary, remove the speaker cloth
F.
Figure 5.9 Removing the speaker
B
Torx T6 screw K1.8x5 PT
E
speaker adhesive ring
C
speaker clamp
F
speaker cloth
D
speaker
B
3656z_01
C
D
E
F
To Next Page
Loading...
