Tait TP9100 - Page 119

TP9100 Service Manual Disassembly and Reassembly 119
© Tait Electronics Limited May 2005
Fitting the
LCD Assembly and
the Front-Panel
Loom
The circled numbers in this section refer to the items in Figure 5.14.
1. Open the lock of the LCD connector on the back of the main-shield
assembly
C.
2. Feed the loom of the LCD assembly
D through the cut-out in the
main-shield assembly.
3. Use rubber-nose pliers to carefully insert the loom of the LCD
assembly into the LCD connector.
4. Make sure that the loom is correctly seated, and lock the connector.
5. Open the lock of the front-panel loom connector on the back of the
main-shield assembly.
Important Make sure that the side of the front-panel loom
B labelled
“OUTSIDE” faces to the closest side of the chassis.
6. Use rubber-nose pliers to carefully insert the side of the front-panel
loom
B labelled “KEYPAD” into the connector.
7. Make sure that the front-panel loom is correctly seated, and lock the
connector.
Figure 5.14 Fitting the LCD assembly and the front-panel loom
B
front-panel loom
D
LCD assembly
C
main-shield assembly
C
D
LCD connector
loom of LCD assembly
cut-out
front-panel loom
connector
B