Tait TP9100 - Page 89

TP9100 Service Manual General Information 89
© Tait Electronics Limited May 2005
4.6 Shielding Cans and Connectors
The shielding cans on the top- and bottom-side of the main board are
identified in Figure 4.3. The figures also show the locations of the
connectors on the board.
Figure 4.3 Shielding cans and connectors
DIG BOT
REG
1V8
TOP
FCL TOP
SYN TOP
DIG TOP
CDC TOP
VCO TOP
REG 5V
TOP
PA EX TOP
LO2
TOP
RX FE TOP
MIXER
TOP
VCXO BOT
SYN BOT
VCO BOT
CDC BOT
REG 3V3
BOT
PA BOT
PA LPF
BOT
TX CONTROL
BOT
IF IQ
BOT
accessory
connector
[PL1]
front-panel interface
connector ([PL2]
battery pins
speaker pins
antenna SMA
connector
[SK3]