Tascam 388 Studio 8 - Page 31

'V.
Vs
MONITOR SUBMIX AND PHONES SECTION
©MONITOR GAIN and PAN
There are eight sets of these controis on the
top panel, one for each PGM Buss or recordar
Track. They control the level (GAIN) and
left-to-right placement (PAN) of the signal
that is then sent to the STEREO MASTER
Fader, MONO switch, STEREO OUT(s), MONI
TOR OUT(s), PHONES jacks, and STEREO
L/R Meters.
©MONITOR/PHONES Level Control
This rotary control determines the signal
level (volume) that is sent to the PHONES
Jacks and MONITOR OUT(s).
©MONITOR OUT(s)
These ROA connectors provide a line-level
signal and are normally used with a stereo
amplifier/receiver and monitor loudspeakers.
® MONITOR/PHONES Select Switches
There are three of these on the top panel
near the recorder's transport controis. They
are marked: STEREO, AUX, and EFF. They
determine what signal will be heard in the
headphones and be sent to the MONITOR
OUT(s).
©PHONES Jack(s)
There are two of these located on the front
panel of the Studio 8, These are stereo head-
phone jacks. NEVERI use mono headphones
with these connectors.
3n¡>
{1/4" phone 2-connector)
3ni>
(1/4" phone 3-connector)
Monitor Source with MONITOR/PHONES Selector in STEREO*
ASSIGN
L/R
Switch
CUE/PGM
Switch
REC FUNCTION
Switch
INSERI
Switch
Transport
Mode
Monitor Source
Off (n)
PGM ( a )
— — —
PGM
CUE (n)
On ( a.)
On ( ia)
PLAY
tape**
REC PGM
Other modes
than PLAY and
REC
(no sound)
Off (n)
—
PGM
Off (n)
-
PLAY,REC TAPE
Other modes
than PLAY and
REC
(no sound)
On ( a) — -
—
-
L/R STEREO
LED stays on
in PGM
position.
LED flashes with
the transport REC
off; and stays on
with the REC on.
LED stays on
in the down
position.
NOTES:
* Positions other than STEREO have nothlng to do with the setting of the switches shown in the chart.
** does not include TAPE signal in RMX (Remix) mode (they pertain to "PGM").
©-
©
OUNCHIM OUt
©1^ ®
©
J
- 31