Tool List
Page 22
E-451 & E-457
ME-45X-01
Tool List
The tools shown here are generic for
servicing Taylor-Dunn vehicles. Not all tools
will be required for servicing this vehicle.
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
43-201-50: Pinion Seal Installation Tool
Used to install the pinion seal on all vehicles
equipped with the Power Traction primary
reduction and a pinion brake or speed
sensor.
41-532-50: Chain Case Centering Tool
Used to center the chain case cover on all
vehicles equipped with the Power Traction
primary reduction and a pinion brake or speed
sensor. Includes instructions.
77-201-00: Battery Filler
Used to safely add water to batteries.
Equipped with splash guard and auto-
shutoff when cell is full.
75-442-55: Pin Removing Tool
Removes pins from Molex Mini-Fit harness
connectors.
77-200-00: Hydrometer
Used for testing battery electrolyte.
Illustration is of a typical hydrometer, actual
hydrometer type may vary.
To Next Page
Loading...
