What to do if TDE MACNO OPD EXP shows alarm due to wrong power supply in the Power board (15V wrong)?
If the TDE MACNO Controller displays an alarm due to the wrong power supply in the Power board (15V wrong), verify the power supply settings and voltage.
How to fix alarm due to Power board fault (Micro’s watchdog) in TDE MACNO OPD EXP?
If the TDE MACNO Controller displays an alarm due to a Power board fault (Micro’s watchdog), reset or replace the Power board.
General| Brand | TDE MACNO |
|---|---|
| Model | OPD EXP |
| Category | Controller |
| Language | English |
Section for motor start-up to achieve best coupling between drive and motor.
Parameters related to drive characteristics: voltage, current, frequency.
Parameters defining motor characteristics: current, voltage, frequency, poles.
Parameters for motor sensor setup and fine-tuning for performance.
Procedures for auto-tuning drive parameters and measuring motor.
Regulation loops for speed, flux, or voltage control.
Parameters and functions for managing speed references.
Parameters for setting torque and current limits for protection.
Functions to prevent damage to drive and motor.
Setting voltage limits for DC bus, mains, and soft start.
Protection against motor and drive overheating.
Configuring analog and digital inputs.
Configuring digital and analog outputs.
Control functions for motor movement.
Configuration and operation of the PID controller.
Configuration parameters for Modbus communication.
Configuration for CANopen communication.
Digital commands for drive operation.
Safety stop functions.
Troubleshooting without alarms.
Troubleshooting with alarms.
To Next Page
