TDK-Lambda GH10-150 - Page 160

149
Function
Single or Master Role
Constant Power Function
OFF
Constant Power Set Point [W]
RATED VOLTAGE MULTIPLYED BY RATED CURRENT
Slew Mode
OFF
Voltage Slew Up / Down [V/mS]
999.99
Current Slew Up / Down [A/mS]
999.99
Internal Resistance Function
OFF
Internal Resistance Set Point [Ω]
0.001
Voltage Reference Programming Source
DIG
Current Reference Programming Source
DIG
Analog Mode Current Limit (OCL)
OFF
Analog Programming & Monitoring Range [V]
5
Programmable Pin 1
OFF
Programmable Pin 2
OFF
Front Panel Remote Mode
LOCAL
Front Panel LOCK
OFF
Output Sense (LOC / REM)
LOC
Interlock (ILC) Function
OFF
Enable (ENA) Function
OFF
Enable (ENA) Polarity
REV
Power Supply OK (PS_OK) Delay [S]
00.01
Preload
ON
Communication Interface
Not Affected (Preserves Setting)
Communication Power Supply Address
Not Affected (Preserves Setting)
Communication Baud Rate [Baud]
Not Affected (Preserves Setting)
Communication Language
Not Affected (Preserves Setting)
LAN parameters
Not Affected (Preserves Setting), except Host Name
Special Voltage Upper Limit (SVUL)
RATED
Special Current Upper Limit (SCUL)
RATED
Enable registers
Not Affected (Preserves Setting)
Event registers
Not Affected (Preserves Setting)
Power-On Status Clear
Not Affected (Preserves Setting)
Display Brightness
Not Affected (Preserves Setting)
Display Dim Delay [S]
Not Affected (Preserves Setting)
Display Dim Brightness
Not Affected (Preserves Setting)
Factory Calibration Parameters
Not Affected (Preserves Setting)
Table 5-3: Single or Master Roles Non-Volatile Memory Parameters
NOTE
LAN non-volatile memory parameters are not affected (for default parameters, refer to
Table 2-7:
LAN Non-Volatile Memory Parameters ). The only affected parameter is the Host Name which is
updated to default due to system identification update.