4. PROGRAMMING OPERATIONS EO1-11148
4.4 Store Message and Commercial Message Programming (Submode 1)
4- 6
4.4 Store Message and Commercial Message Programming (Submode 1)
Store Message and Commercial Message to be printed as receipt header can be programmed here.
Anytime outside a sale
Control Lock: SET
01 [#/NS] |Line No.
| [#/NS]
Character Entries [AT/TL] [#/NS]
NOTES: 1. For each line, up to 24 regular-sized characters or 12 double-sized characters can be
entered. Also a combination of both types can be entered.
2. If incorrect characters are programmed, depress the [C] key to clear all characters on a
line and then re-enter characters from the beginning, or end the line with the [AT/TL]
key and reprogram the entire line. The new data will be active.
3. When all the lines have been programmed, do a check by issuing a receipt. Only the
lines with errors require to be re-programmed. Other lines will be truncated.
4. When spaces are entered for the whole one line, it causes one line not to be printed.
Example)
To program the following Store Message and Commercial Message
Max. 24 characters/line
(See 4.2 Character Entry
Method.
2 digits (01 to 07)
(See NOTE 2 below.)
(For sequentially programming lines,
the Line Number specification can be
skipped.)
Repeat for other lines.
Complete this
line.
Complete this
programming
operation.
Line No. 1
Line No. 2
Line No. 3
Line No. 4
Line No. 5
Line No. 6
Line No. 7
1 3 4 3 P E A C H D R I V E
PH O N E : 87-6437
O p e n 8 : 0 0 a m t o 7 : 0 0 p m
C l o s e d : e v e r y W e d n e s d a y
T E C S T O R E
OPERATION
CONDITION
To Next Page
Loading...
Need help?
General
