12. GENERAL MAINTENANCE EO1-11148
12.5 Drawer Key
12- 3
3. To remove the Partition from the Coin Case, pull the
Partition upward. Set the Partition in the groove where you
like, then push down the Partition.
4. To change the layout of the Bill Case, it is necessary to
remove the Bill Holder. To remove the Bill Holder, remove
the three screws to detach the Bill Holder Ass’y from the
Money Case. Then remove the screw to detach the Bill
Holder from the Plate. To remove the Partition, pull it
upward.
12.5 Drawer Key
Insert the Drawer Key into the Drawer Key Lock, then turn it
90° counterclockwise to lock the Drawer.
LOCK
RELEASE
To Next Page
Loading...
