TEC MA-1535 series - Cashier Code and Name Programming (Submode 2)

4. PROGRAMMING OPERATIONS EO1-11148
4.5 Cashier Code and Name Programming (Submode 2)
4- 8
4.5 Cashier Code and Name Programming (Submode 2)
Anytime outside a sale
Control Lock: SET
02 [#/NS] |Cashier Code
| [#/NS]
Character entry [AT/TL]
|Pass Code
| [AT/TL]
|HALO
||LALO|* [AT/TL]
|Commission Rate
| [AT/TL]
|Commission Amount
| [AT/TL]
|Security Code 1
| |Security Code 2| [AT/TL]
|Cashier Status
| [AT/TL]
[#/NS]
OPERATION
CONDITION
Max. 18 characters
(See NOTE 2 on the next page.)
2 digits (01 to 99)
Repeat for other cashiers.
01: Cashier Name
3 digits (000 to 999)
(See NOTE 3 on the next page.)
02: Cashier Pass Code
1 digit 1 digit
03: High Amount Limit/Low Amount Limit
0.00 to 99.99%
(Use the [.] key when a decimal
point is contained in the rate.)
04: Commission Rate
1 digit (0 or 1)
0: Commission Amount = (Net Sale without Tax) x (Commission Rate)
1: Commission Amount = (Net Sale with Tax) x (Commission Rate)
05: Calculating the Commission Amount (This calculation is operable in VAT specification only.)
2 digits (Enter the codes in numeric values.)
(Refer to Cashier Security Code Table**.)
06: Cashier prohibited item
1 digit (0 to 2)
0: Cashier for sale entries
1: Supervisor (See NOTE 4 on the next page.)
2: Cashier for training entries (See NOTE 5 on the next page.)
07: Cashier Status
To complete this programming operation.