TEC MA-1535 series - Programmed Data Verification; PLU and Department Data Verification

To Next Page

To Previous Page

5. PROGRAMMED DATA VERIFICATION EO1-11148

5. PROGRAMMED DATA VERIFICATION

5- 1

5. PROGRAMMED DATA VERIFICATION

Whenever programming operations are performed, it is recommended to issue Program Verification

receipts to check the programmed data before entering any other operation. The print format of each

program reading is almost the same as that of the program receipt.

Anytime outside a sale

Control Lock: X or SET

1) Programmed data read for each Submode

• X mode

90 [AT/TL] 01 [#/NS] |Submode No.| [AT/TL] [#/NS]

• SET mode

90 [#/NS] 01 [#/NS] |Submode No.

| [AT/TL] [#/NS]

NOTE: Printing will be cancelled by depressing the [C] key during report print.

2) Zone PLU Read

• X mode

90 [AT/TL] 02 [#/NS] |Zone-start PLU Code| [X/TIME] |Zone-end PLU Code| [AT/TL] [#/NS]

• SET mode

90 [#/NS] 02 [#/NS] |Zone-start PLU Code| [X/TIME] |Zone-end PLU Code| [AT/TL] [#/NS]

NOTES: 1. Printing will be cancelled by depressing the [C] key during report print.

2. The Zone-end PLU Code must be bigger than the Zone-start PLU Code. Failure to do this

may cause an error.

OPERATION

2 digits (01 to54)

CONDITION

13 digits

TEC STORE

1343 PEACH DRIVE

PHONE: 87-6437

Open 8:00am to 7:00pm

Closed: every Wednesday

26-01-2002 #1234

X 90

SECTION 04

1000000010101

-01 Tomato

-02 1.00

-03 1.20

-04 1.40

-05 15

-06 01

-07 01

-08 0

-09 00

-10 00

-11 00

-12 00

-13 100.00

1000000010102

Zone-start PLU Code

Zone-end PLU Code

When the report is issued

in X mode:

When the report is issued

in SET mode:

PRG

-01 Potato

-02 0.80

-03 1.00

-04 1.20