8. INSTALLING AND REPLACING THE RECEIPT AND JOURNAL ROLLS EO1-11148
8.1 Installing/Replacing the Receipt Roll
8- 1
8. INSTALLING AND REPLACING THE RECEIPT AND
JOURNAL ROLLS
Turn the control lock to the REG position using a Mode Selector Key to perform the paper roll
installation described in this chapter.
8.1 Installing/Replacing the Receipt Roll
WARNING!
Care must be taken not to injure yourself with the paper cutter.
1. To remove the Printer Cover, insert the Printer
Cover Key to the Printer Cover Lock, and then
turn it 90° clockwise.
2. When replacing the receipt, cut the paper at the
arrow indicating position in the figure on the left.
Press down the [RF] key to take away the cut
paper.
CAUTION: Never try to pull out the remaining
paper end by hand. It may cause a
paper jam.
3. Cut the new paper roll’s paper end straight to
make it sharp.
4. Place the paper roll into the left holder as viewed
from the front of the machine so that the paper
end will be fed from the bottom.
To Next Page
Loading...
Need help?
General
